Welding sculpture with wood together:

For this, already new methods are developed, is but in the friction-welding feasibly for a long time. (Such as at wood fibre -- form substances). With considerable advantages, as this at the circular welding. Thermoplastic material with the circle vibration into the wood structure of in difundiert. After cooling off the synthetic material is got stuck with the wood which a high strength yields. The car manufacturers have already made use of it 25 years ago to weld Retainer/holder on the interior trim of car doors. It is another advantage it is rubbed appropriately longer that the area of the holder made of plastic does not have to be adapted with an easy 3D form of the wood. The synthetic material is worn out till he full flatly is tricked on the wood and the process is then switched to the cooling phase. In the past, badly attainable range of small sweat units by the 40 kg were added to robot for bad and nowadays we have developed the smallest hand welding equipment of the world which takes even the contact pressure at the welding with 14 kg without the worker still having to stop. With this innovation it would be possible "to weld synthetic material together with wood" but to be able to offer DIY shop articles for the final consumer to e.g. weld on holders in a summer house for gardening tools. The quantity is and the costs for the production too high too low at this new market till now. A costs/use would be interesting by a renting device for the final consumer also pricewise, though.

You see a picture of Retainern below, which are used in the car construction, the holders can be adapted to every application and can one conceal the welding drove out with an overhang. In the picture the welding drove out so much is not urgently we either, this serves only the representation of the melt of welding.